Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a bit however it's still attractive. It's not the most luxurious car in its class and it's a Ford Focus or Volkswagen Golf will protect you from road imperfections, however, it's a comfortable and a civilized driving experience.
We often receive requests from Coded Car Keys to replace peugeot key fobs. No matter if the issue is intermittent or constant the following tips will aid.
Water Damage
If you leave your fob in the midst of a puddle or splash it with water when kayaking, swimming, canoeing, rafting or canyoning, it's more likely to sustain water damage. Keep your key fob in a dry, dry bag each time you are outside or perform activities that could expose it to excessive water.
It's also essential to make sure that the fob has dried before you open it up and then use it again. If you smell any odors from the fob (such as industrial fluid or windshield washer fluid) This is a further indication that it's submerged.
A wet circuit board can cause the battery to lose its charge, or even explode. If you're able to fish your key fob 308 out of whatever body of water it got stuck in then flip the button side down and shake it out as much water as possible before opening the case. Remove the battery, then wipe the circuit board down with a cotton swab, which has been dipped into 90-percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system that you use to enter your home may stop working include a dead battery for your coin, receiver module issues, signal interference, or an electronic chip malfunctioning. If none of the above is the reason it is possible to reset the system by removing the 12 volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system which allows the driver to start the car from afar by warming up or cooling down the car prior to entering. This feature is extremely useful, especially in the cold winter months. However, it is possible that the remote start system stops working due to a variety of causes, such as an unresponsive coin battery.
A coin-shaped battery found inside the key fob has a life span of two to four years, depending on how often it is used and where it's purchased. The date of use is typically printed on the package or written in the manual.
If the key fob has stopped functioning after being exposed to clean tapwater, remove the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If you expose it to salty or soapy water, the chip could be damaged and you'll need to replace the key fob in total.
If you are not sure the battery is faulty you can check its voltage using an instrument set to the car's voltage range and connected to the plus and minus terminals. If the voltage is lower than 12-13 volts, you need to replace the battery. You can also try to reset the on-board computer by disconnecting the battery at 12 volts for a few minutes and then reconnecting it in reverse order (positive cable first and then negative). The engine should start.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, then it's possible the receiver module has created a fault. It's the part that sends an alert to the car when your key fob is activated that also acts as an immobiliser. It also stops it from starting unless the correct key is present.
This could result from a variety of causes, such as water damage or simply the aging process. If the chip inside your Peugeot 308 keyfob has been damaged by dirty tap water, it could be because the keyfob was in contact with it. In this scenario it is necessary to take the device apart and clean it thoroughly using isopropyl alcohol or an electronic cleaner. Once it's dry you can put the battery back into the battery and try again.
If the problem persists it is a good idea to consult a local Peugeot expert or locksmith. They'll be able utilize a diagnostic tool to assist in identifying the problem and fix it.
It can be stressful to lose your Peugeot car key. However, a trained auto locksmith can fix the issue in just a few minutes. They can cut a new key and program it to your vehicle, making sure you're back off the road as quickly as possible. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob plays a vital role in the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message that says "anti-theft". If replacement peugeot key www.g28carkeys.co.uk happens, the only way to fix the issue is to purchase a new key. Auto locksmiths with experience are able to provide this service in the shortest time.
The chip inside the chip of your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or any other cause. If your Peugeot key fob was exposed to dirty or soapy water, it must be cleaned promptly. You can clean the electronic component using paper towels soaked with isopropyl Alcohol. After that, let the battery dry completely.
Sometimes the key fob may not function due to radio interference. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects in the vicinity. It is recommended to visit a Peugeot dealer if you experience this problem.
The Peugeot Key Fob 207/308 is delicate and needs special attention. It should not be dropped or throw it around. If you lose something, try to find it as quickly as you can. You can reset the on-board computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative first, and then the positive.